HONEYWELL 5881ENH PDF

Hang two mounting clips provided with the receiver on the raised cabinet tabs, as shown in Detail B of Figure 1. Insert the top of the receiver board between the rows of slots at the top of the cabinet, as shown in Detail A. Position the base of the receiver board onto the mounting clips and secure to the cabinet with the supplied screws. See Detail B. Hang two mounting clips supplied with the control board , on the raised cabinet tabs as shown in Detail C in Figure 1. Insert the top of the control board into the slots of the mounting clips secured in step e above.

Author:Dousho Tarisar
Country:Timor Leste
Language:English (Spanish)
Genre:Career
Published (Last):24 March 2018
Pages:436
PDF File Size:4.44 Mb
ePub File Size:2.13 Mb
ISBN:197-8-89211-193-7
Downloads:53033
Price:Free* [*Free Regsitration Required]
Uploader:Akinorn



Hang two mounting clips provided with the receiver on the raised cabinet tabs, as shown in Detail B of Figure 1. Insert the top of the receiver board between the rows of slots at the top of the cabinet, as shown in Detail A. Position the base of the receiver board onto the mounting clips and secure to the cabinet with the supplied screws. See Detail B. Hang two mounting clips supplied with the control board , on the raised cabinet tabs as shown in Detail C in Figure 1.

Insert the top of the control board into the slots of the mounting clips secured in step e above. Position the lower end of the control board into place on the mounting clips and secure both to the cabinet with the two supplied screws.

Insert both grounding lugs supplied with the receiver through the top of the cabinet into the left-hand terminals of the antenna blocks located on the upper edge of the receiver board , and secure them to the cabinet with the screws provided, as shown in Detail D. If the receiver is to be located remotely from the control in its own plastic enclosure not in a cabinet : You will not need the circuit board mounting clips, grounding lugs and screws included with the receiver.

If concealed wiring is to be used, route it through the rectangular opening at the rear of the base before mounting. Mount the receiver in the selected location. For greatest security, use all four mounting holes two key slot holes and two round holes provided in the plastic base. If installing a ENHC, install a flat-head screw e.

When the receiver is pried from the wall, the tamper tab will break off and remain on the wall. This will activate a tamper switch in the receiver and cause generation of a tamper signal.

I CAPULETI E I MONTECCHI LIBRETTO PDF

Honeywell Ademco 5881EN Series Installation And Setup Manual

.

EL CATALEJO DORADO PHILIP PULLMAN PDF

Honeywell 5881ENM

.

Related Articles