Page of 40 Go. For customer orders, contact Customer Service at: Page of 40 Go. Table Of Contents Dimensions Audio Routing Each audio input has a 3-band equalizer and a compressor for The DPM has a real time clock can be switched optimal sound adjustment of the audio sources. Flexible CU strand, LiY, 1.
|Published (Last):||19 November 2008|
|PDF File Size:||19.55 Mb|
|ePub File Size:||19.29 Mb|
|Price:||Free* [*Free Regsitration Required]|
Page Back DPM is disconnected from the voltage supply or if the voltage supply is switched off or fails.
For future applications. See the Section Connections, page 17 Back Figure 5. Page Installation Installation The DPM has been developed for horizontal installation in a conventional 19" rack cabinet. As a rule, the DPM must be mounted in such a way that the ventilation slots are not blocked on either side.
Figure 5. Page Connections AWG16 can be used. Recommended connecting line: Symmetrical cable configuration with flexible 2 x 0.
Although all analog inputs and outputs of the DPM can also have asymmetrical configurations, a symmetrical audio connection cable is a better alternative. The scope of delivery includes a 2-pole connector. Conductor cross-sections of 0. If no network cable is connected, both LEDs remain unlit.
The upper half has eight freely configurable control inputs, and a DCF77 receiver can also be connected. The lower half has six freely configurable control outputs and a ready contact, and slave clocks can also be connected. To integrate the DPM into the hazard alert systems, a normally-closed contact standby current principle is recommended, i. Page Configuration For precise installation instructions, see the description of the respective module. Extension slots Eight slots, which are numbered 1 through 8, are available on the rear panel of the DPM for extending the system.
Page Network Configuration Figure 7. The CM-1 module used here has two Ethernet connections to set up a redundant network. Page 27 ID If at least one of these three conditions is not met, the default IP address of the DPM must be changed.
Example: The following diagram shows a sample application with four DPM controllers in a connected Ethernet.
Dynacord DPM 8016 Owner's Manual
Although all analog inputs and outputs of the DPM can also have asymmetrical configurations, a symmetrical audio connection cable is a better alternative. Anhang Internet verbunden sind, von Interesse. The indicator is off, when the DPM has been separated from the power supply, the power supply has been switched off or in case of power outage. Page of 40 Go. See the Section Connections, page 17 Back Figure 5. DPM Appendix en Symmetrical cable configuration with flexible 2 x 0. The choice of subnet mask and the resulting different split of the IP address into network element and host element have an effect on the maximum number of addressable devices within a network.
Dynacord DPM 8016 Operation Manual
DPM 8016 PDF